V01-2013 35mm-01 serie
19
8.0 MAINTENANCE INSTRUCTIONS.
With the 01-Series delivered tools and spare parts which also can
be ordered separately:
part number:
Tools:
1 x wrench M2,5 to adjust frictions 9962.0088.00
1 x hexagon M4 to adjust picture lamp 9962.0087.00
Cleaning brush N000.0473.00
Cleaning cloths set ( blue and yellow) N000.0521.00
Spare parts:
2 x picture lamp 12V- 100W 9956.1066.00
1 x exciter/optical sound lamp 9956.1080.00
10 x fuse 6,3 Amp. T (5 x 20 mm) 9956.0232.00
10 x fuse 0,5 Amp. T (5 x 20 mm) 9956.0224.00
Various:
Dust cover 9962.1083.00
8.1 Introduction.
The Steenbeck 01-Series doesn’t need much maintenance. It depends on by whom,
how and under what circumstances the table is used. It’s advised to clean the table
every time it has been used with the supplied brush.
Clean the top of the table with the supplied cloth; Start cleaning with a moist
microfiber cloth (Blue) and dry it with the (Yellow ) dry cloth.
Caution: technical maintenance.
When the Steenbeck 01-Series is regularly in use (almost daily basis and more) the
maintenance needs to be done at least once a year by the dealer or Steenbeck
factory engineer. In this service the table will remain in a good condition.
To facilitate the operation the following instructions should be strictly adhered
to. (pages 19 – 23)
= only done by skilled staff
Before opening the machine be sure it is disconnected from the mains.
Only service engineers are authorized to do adjustment and technical maintenance.
The machine should only be operated with the side and front panels closed.
To Next Page
Loading...
Need help?
General
