V01-2013 35mm-01 serie
15
HOW TO USE THE STEENBECK 35mm 01-SERIES. (continued)
5.8 Rewind:
Don’t rewind the film as it is thread for viewing, because of the sprockets, older films
with bad splices and perforation can get damaged.
It’s advised to rewind the film always with a (Steenbeck) film rewinder.
The Steenbeck film rewinder can wind forward and backward and the speed can be
adjusted, even to very slow. This can be useful when it’s required to check or clean
the film by hand.
5.9 Sound:
The 35mm film can be viewed with optical (COMOPT) sound
and separate magnetic sound (SEPMAG).
See for threading film with COMOPT sound and SEPMAG sound pages 30-34.
Hints for optical sound:
-if optical is unused, it’s preamplifier fader should be set to zero position.
-avoid direct exposure of the optical sound reader by room light or table working
lamp. The light sensitive device in the sound reader may be influenced by this
exposure and causing extra audible noise like hum.
Adjustment of the volume with the fader halfway on the preamp first.
(page 10 #29 – 30)
Then the master volume control button (page 10 #27) in the mid .
Adjustment of the sound by treble and bass (page 10 #27)
Plug in a headphone with a ‘1/4”jack’ (page 10 #28).
When a headphone is used, the speakers are off.
Caution:
When the level of the headphone is to low, it’s caused by the impedance of the
headphone
To Next Page
Loading...
Need help?
General
