Stellar
®
5521 Telescopic Crane Owner’s Manual | Page 5
1. Determine that the mounting location for the 5521 crane is at least 18” x 20” (45.7 x 50.8 cm).
2. Use the detail below to drill 1.06” diameter holes into the mounting plate. Run tap on the threads
of the base to be sure they are clean.
3. Use a crane or lifting device capable of lifting the weight of the Stellar® crane. The Stellar
5521weighs approximately 1400 lbs (635 kg). Note: cranes are shipped with rotation
positioned at 200 degrees of 400 degree system. This will allow for easy installation of the
crane and permanent connection of all hydraulic and electrical components prior to repositioning
into the crane saddle.
4. Connect straps or chain from the lifting device to the lifting rings on the 5521.
5. Use four (4) 1” x 3” #8 bolts and four (4) #8 at washers.
6. Install a washer on each bolt.
7. Apply Loctite Thread locker #277 to the bolts.
8. Using the lifting device, lower the 5521 just above the crane compartment and start the bolts.
Have someone assist in leveling the crane. Note: the rotation motor should be to the door
side of crane compartment and the boom should be extended back over the rear bumper.
9. Secure the crane using the mounting hardware provided. Note: longer or shorter cap screws
may be required – recommended thread engagement into crane base is 1.75” – use grade
8, zinc plated cap screws only.
10. Torque the cap screws to 680 ft-lbs.
11. Remove supporting crane.
12. Hook-up hydraulics and electrical.
Installation Overview
1
2
.YTQNOITPIRCSEDTRAPMETI
1 5199CAP SCR 1.00X8X3.00 HHGR8 ZY 4
2 6538WASHER 1.00 SAE FLAT YELLOW GR8 4
Motor
Hole Mounting Detail
Ø1.063
7.38
14.75
7.38
14.75
Ø6.00
4 Places
To Next Page
Loading...
