Stenograph WAVE - Install the Wave USB Driver

Wave User Guide
12
© 2017 Stenograph
Install the Wave USB Driver
Install the necessary Wave USB driver on your computer. The USB driver allows communication via
USB cable between the Wave writing machine and your computer. This includes reading notes, realtime
writing and installing updates.
The Wave USB device drivers are available for download from the Stenograph website at
www.stenograph.com. At the Stenograph website: click Support, Download Center and Utilities & links.
Right click the on the Stenograph Writer USB Drivers and select Save Target as or Save Link as and
save the file to a location on computer desktop or your hard drive.
1. Turn your computer On. Ensure it is fully booted.
2. The Wave USB device drivers are available for download from the Stenograph website at
www.stenograph.com. At the Stenograph website: click Support, Download Center and Utilities &
links.
3. Right click the on the Stenograph Writer USB Drivers and select Save Target as or Save Link as
and save the file to a location on computer desktop or your hard drive.
4. Navigate to the location where you saved the file, highlight the file, right click and select Extract All.
Then double click the StenographDriverInstall.exe to install the drivers.
The Windows Security screen may display, prompting you to install the Stenograph L.L.C. Ports
(COM & LPT) virtual serial driver. Click the option, Always trust software from “Stenograph” and
then click Install. If a second prompt displays for the Stenograph USB Writer driver, click Install.
5. The Wave driver installation begins.
6. Once the drivers install, the Stenograph Writer Drivers Setup Complete dialog box displays. Press
Enter (Finish) to close the wizard.