Stenograph WAVE - USB Communication Option

59
Chapter 4: Writing on the Wave
© 2017 Stenograph
USB Communication Option
The Wave uses the same realtime USB protocol as the élan Mira
®
; however, some CAT systems look
specifically for the writer model instead of the USB protocol. The USB Communication option allows you
to switch the USB protocol from Standard to emulate the élan Mira, enabling you to connect your CAT
system to the Wave via USB cable for realtime communication.
The USB Communication option only affects realtime communication via USB. Virtual USB serial port
communication is not available.
To change the USB Communications option:
1. From the Opening Menu, press Setup, Options.
2. Use the Up/Down buttons to highlight the USB Communication (Wave will Reset if Changes): field.
3. Press Change to switch to Mira Emulation or Standard. Standard is the default selection.
4. The message, “Changing the USB Communications Option Causes the Wave to Reset.” displays.
5. Press OK. The Wave changes the USB protocol, resets and displays the Opening menu. The setting
remains until changed.