29
Chapter 3: Wave Hardware Features
© 2017 Stenograph
Reset
The Reset button is a small, recessed button located on the back of the Wave to the left of the AC
Adapter/Charger port.
Like other computer equipment, the Wave can seem unresponsive when it receives a series of
commands it does not recognize. If the Wave appears unresponsive, press the Reset button on the
back of the Wave. When you press the Reset button, the Wave reboots and is then ready to use.
If you had a file open before pressing Reset, the Wave ends the job and the file closes. Start writing to
create a new job.
To Next Page
Loading...
