Stenograph WAVE - Prompt to End a Job Option

49
Chapter 4: Writing on the Wave
© 2017 Stenograph
Prompt to End a Job Option
The Wave can optionally prompt you with a confirmation message each time you press the End button to
close a job. When the message displays, you can continue to close the job by selecting End again.
Pressing Cancel or continuing to write cancels the message and the job remains open.
To set the end job confirmation prompt:
1. From the Opening menu, press Setup, Options.
2. Press the Up and Down buttons as necessary to highlight the Prompt to end job option.
3. Press the Change button to toggle the option between Yes and No. No is the default.
4. To display the Opening menu, press OK, More, Quit.