Stenograph WAVE - Tilting Screen Appearance

Wave User Guide
56
© 2017 Stenograph
Tilting Screen Appearance
You can adjust the font size and backlight level on the Tilting screen. The font size is only adjustable
before beginning realtime. The brightness level is adjustable before or during realtime.
Select Tilting Screen Font Size
The Wave can display steno outlines in five different font sizes. Using a smaller font allows you to
display more steno strokes on the Tilting screen and using a larger font allows for easier viewing. The
default font size setting is #3.
To change the Tilting screen font size:
1. From the Opening menu, press Setup, Display.
2. On the Display menu, press Font.
3. Move the pointer (>>) using the Font and Font buttons to select one of the font sizes.
4. When finished with your selection, press OK. The Display menu reappears. The selected font size
remains until changed.
5. To return to the Opening Menu press Quit, More, Quit.
Set the Tilting Screen Backlight Level
Adjust the brightness of the Backlight on the Tilting screen to accommodate your viewing preference.
Decreasing the brightness reduces the amount of the power required to display the screen which can
reduce battery consumption. Optionally, setting the Backlight to automatically dim after a period of
inactivity also reduces battery consumption. Dimming options allow you to customize automatic dimming
when selected.
To customize the Tilting screen Backlight levels:
1. Do one of the following:
• From the Opening menu, press Setup, Display, Backlight.
• From the First Writing menu, press More, Setup, Display, Backlight.
2. Press the Up and Down buttons to highlight an option. Use the + and - buttons to make changes.
• Backlight Bright Level—Increase or decrease the Backlight level. The brightness is based on a
percentage. 100% is the default. The screen reflects your selection.
• Backlight Dim Level—Set the Backlight dimming level when the Auto Dim After option is active.
The brightness level is based on a percentage. The screen reflects your selection.
• Auto Dim After—Select the period of inactivity that must pass on the Wave before Backlight
dimming occurs. Choose a number between 1-90 seconds or Never.
• Auto Bright When—Select the action that must be taken to resume regular Backlight brightness
after dimming. Choose Steno or Function Key.
3. When finished with your selections, press OK. The Display menu reappears.