63
© 2017 Stenograph
Appendix A, Installing the USB Driver, instructs you how to install the USB driver required when using a
USB cable to connect your Wave with Case CATalyst, other CAT software and install updates. You can
only use USB Realtime and Read communications with USB compatible CAT software such as Case
CATalyst version 4.096 or higher.
The USB installation instructions include installing the USB driver that creates a virtual serial port. If your
CAT vendor does not support a USB realtime connection, this driver allows for serial communication
between the Wave and CAT software. See USB Virtual Serial Port Communication on page 25 for
details on USB virtual serial port communication.
When loading the Wave USB device drivers, the User Account Control or Permissions message box
displays. The User Account Control (UAC) is a security feature prompting you for permission to run the
displayed program name or service being accessed. To load the Wave device drivers, you must choose
Allow in the UAC or Permissions message box. The User Account Control is an important security
feature of Windows operating systems. Stenograph does not recommend disabling it.
Complete the instructions to install the USB Wave device drivers running a Windows 32-bit or 64-bit
operating system. Installing the drivers to one USB port on a computer running Windows 7, 8.x or 10
automatically installs the drivers to all the USB ports. Depending on your operating system, screens may
vary slightly.
The Wave USB drivers are available for download from the Stenograph website. Follow the appropriate
instructions in this appendix to load the USB drivers on a computer using a Windows 10, Windows 8 and
Windows 7. If you have questions about installing the Wave USB driver, please contact Stenograph
Technical Support at
1.800.323.4247 or 1.630.532.5100.
Appendix A
Installing the USB Drivers
To Next Page
Loading...
