Wave User Guide
54
© 2017 Stenograph
Steno Test
The Steno Test feature puts the Wave in writing mode and simulates steno strokes for diagnostic
purposes. This feature is generally used at the request of a Stenograph Technical Support
Representative to test the Read and Writing features of the Wave.
To activate Steno Test:
1. From the Opening menu, press Diag, Steno Test.
2. Writing any steno stroke exits the Steno Test mode but keeps the file open. To close the file, press
End.
If the option, Prompt to confirm ending job is active, a confirmation prompt displays. Press End to
close the job or continue writing to cancel the message.
To Next Page
Loading...
