55
Chapter 4: Writing on the Wave
© 2017 Stenograph
Test Mode
Test mode allows you to write to the realtime screen without writing to memory. The Wave must be
connected to the computer for realtime writing. A testing facility may request this mode when you take a
certification test.
To turn Test Mode On or Off:
1. Connect the Wave to your computer for realtime writing. For more information, See Connect for
Realtime Writing on page 23.
2. From the Opening Menu, press Setup, Test Mode. The Status and Menu bars display in red to
indicate that the Wave is in Test mode. The Wave remains in Test Mode until you turn the feature Off
or turn the Wave Off.
3. To display the Opening menu, press OK, More, Quit.
To Next Page
Loading...
