© STid – MU_ULTRYS_V3.0.1_EN
Value add in front of the data to indicate the technology read.
Available only if a Bluetooth
®
configuration is active.
Used to fix the first ID bit sent by the reader to the OSDP_RAW command (UID and Private ID).
Adjustable from 0 to 255 bits.
Ex: if the offset is 6 and the data is 0x123456 (hexa), 0b0001 0010 0011 0100 0101 0110 (binary).
➔The data with the offset will be 0b10 0011 0100 0101 0110 (binary), 0x023456 (hexa).
Allows adding zero padding to the left or right (left justified or right justified).
Disabled: after an osdp_keyset command with a key other than the default SCBKD key, it is
mandatory to communicate in Secure Channel.
Enabled: After an osdp_keyset command with a key other than the default SCBKD key, it is
possible to communicate in plain mode even after successful authentication.
Allows the RS485 address to be defined, by OCB configuration without having to use the
osdp_COMSET command.
Allows to force a site code. The value of the code will be transmitted in high order on one or two
bytes. The CSN can therefore be truncated depending on the size of the protocol used. Available
only if a Bluetooth
®
configuration ‘Private ID reading mode otherwise CSN’ or ‘CSN only’ is active.
Disabled: the response will be osdp_busy.
Enable: the response will be osdp_ACK.
Disabled: uses IEEE 0x2C17E0.
Enabled: uses IEEE 0xF51BC0.
To Next Page
Loading...