Stid ultrys - Windows Installation; Compatibility ULTRYS; Reader Range; User Ids; Compatibility Ultrys; Firmware Reader

7
© STid – MU_ULTRYS_V3.0_EN
Windows Installation
1. Insert the ULTRYS v2 USB stick on an USB port of your PC.
2. Wait for the automatic opening of the browser window.
3. Launch ULTRYS V2.x.x_setup.exe.
4. Follow the instructions on the screen.
Compatibility ULTRYS / Reader Range / User IDs
This ULTRYS version (3.x.x) allows you to configure SPECTRE, SPECTRE NANO, ATX and
ATX4 readers.
To configure URx & GAT readers, please use ULTRYS v1.x.x.
ULTRYS v1
ULTRYS 3.0
SPECTRE + SPECTRE ANTENNA
x
✓
SPECTRE + URD ANTENNA
x
✓
URx + URD ANTENNA
✓
x
URx + SPECTRE ANTENNA
✓
x
Credential encoding in secure
mode
x
✓
Warning:
• To read credentials encoded with ULTRYS v1 on a SPECTRE reader:
configure the EPC reading in Mode 1(standard) and do not use the EPC filter.
• Credentials encoded with ULTRYS v2 will not read on the Urx /GAT readers.
Compatibility ULTRYS / Firmware reader
This ULTRYS version (3.x) allows you to configure SPECTRE, SPECTRE NANO, ATX and
ATX4 readers according to the firmware version of the reader.
ULTRYS v2.0
ULTRYS v2.1
ULTRYS v2.4
ULTRYS v3.0
Firmware v7




Firmware v9



Firmware ≥ v10


Firmware ≥ v13
