Stid ultrys - Step 6- Light Indicator Configuration

185
SPECTRE ATX READ ONLY
© STid – MU_ULTRYS_V3.0.1_EN
Summary table
Note: as long as the action is detected on the input, the output remains toggled.
Step 6- Light indicator configuration
The SPECTRE ATX reader is not equipped with an LED card or a Buzzer.
Step 6 does not exist in the SPECTRE ATX setup wizard.
Reading Mode
Input
Configurable
Outputs
states?
Maintain
during
detection
available?
Output
Continuous
reading without
using inputs
No action
Yes
by lane
Yes
by lane
- If ‘Continuing during
detection process’ not
activated: the output state
toggles at the ascent
- If ‘Continuing during
detection process’
activated: the output state
toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection
Trigger of the
reading by the
event
An action on the
input activates the
reading on the
lane
Yes
Yes
- If ‘Continuing during
detection process’ not
activated: the output state
toggles at the ascent
during the ascent time of
the identifier (physically
on the BUS + 200ms
- If ‘Continuing during
detection process’
activated: the output state
toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection
Output
activation
(triggered on
outputs)
An action on an
Input toggles the
corresponding
output
Yes
No
The output state is only
linked to a user action on
the input
b
a
c