Stid ultrys - Step 6- Light Indicator Configuration

235
SPECTRE ATX 4 READ ONLY
© STid – MU_ULTRYS_V3.0.1_EN
Summary table
Note: as long as the action is detected on the input, the output remains toggled.
Step 6- Light indicator configuration
Step 6 does not exist in the SPECTRE ATX4 configuration wizard.
Reading Mode
Input
Configurable
Outputs
states?
Maintain
during
detection
available?
Output
Continuous
reading without
using inputs
No action
Yes
by lane
Yes
by lane
- If ‘Continuing during
detection process’ not
activated: the output
state toggles at the
ascent
- If ‘Continuing during
detection process’
activated: the output
state toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection
Trigger of the
reading on all
lanes
An action on any
input activates the
reading on all
configured lanes
Yes
by lane
Yes
- If ‘Continuing during
detection process’ not
activated: the output
state toggles at the
ascent during the ascent
time of the identifier
(physically on the BUS +
200ms
- If ‘Continuing during
detection process’
activated: the output
state toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection
Trigger of the
reading on the
event lane
An action on Input
x activate the scan
on lane x
Yes
by lane
Yes
Output
activation
(triggered on
outputs)
An action on an
Input toggles the
corresponding
output
Yes
No
The output state is only
linked to a user action on
the input
a
b
c
d