The reader emits the credential code present in the field only once during this time.
This time is adjustable from 0 to 30 seconds.
If the Reading Mode has been set to ‘UHF then Bluetooth
®
‘or ‘Bluetooth
®
then UHF’, the
timeout setting appears:
UHF then Bluetooth
®
: If beyond the Timeout no valid Bluetooth
®
identifier is read, the reader
starts again in UHF scan.
Bluetooth
®
then UHF: If beyond the Timeout no valid UHF identifier is read, the reader starts
again in Bluetooth
®
scan.
To Next Page
Loading...