Stid ultrys - Page 34

34
© STid – MU_ULTRYS_V3.0_EN
SPECTRE READ ONLY
Summary table
Note: as long as the action is detected on the input, the output remains toggled.
Reading Mode
Input
Configurable
Outputs
states?
Maintain
during
detection
available?
Output
Continuous
reading without
using inputs
No action
Yes
by lane
Yes
by lane
- If ‘Continuing during
detection process’ not
activated: the output
state toggles at the
ascent.
- If ‘Continuing during
detection process’
activated: the output
state toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection.
Trigger of the
reading on all
lanes
An action on any
input activates the
reading on all
configured lanes.
Yes
by lane
Yes
- If ‘Continuing during
detection process’ not
activated: the output
state toggles at the
ascent during the ascent
time of the identifier
(physically on the BUS +
200ms.
- If ‘Continuing during
detection process’
activated: the output
state toggles to the RF
detection and remains in
this state as long as, at
each scan is at least one
detection.
Trigger of the
reading on the
event lane.
An action on Input
x activate the scan
on lane x .
Yes
by lane
Yes
Activation of the
custom LED
(triggered by
the event)
Custom LED
lighting for all
antennas / lane
No
No
In this mode the Outputs
are not usable.
Output
activation
(triggered on
outputs)
An action on an
Input toggles the
corresponding
output.
Yes
No
The output state is only
linked to a user action on
the input.
a
d
b
c
e