OPERATION
Operation
www.stiebel-eltron.com WPF basic | 15
4.5.8 HEATING PROG
The HEATING PROG parameter enables you to determine when and
how often the appliance heats to the set day values for heating
circuit 1 and 2. At all other times, the appliance heats to the set
night temperature. You will have already selected the set values
under menu item ROOM TEMP HC1/2.
You can adjust your heating system as follows:
- for each individual day of the week (Monday, ..., Sunday)
- Monday to Friday (Mo – Fr)
- Saturday and Sunday (Sa – Su)
- the whole week (Mo – Su)
You can adjust three switching time pairs (I, II, III) for each of
these options.
Example:
For heating circuit 1, your heating system should provide heat
daily from Monday to Friday at two different times, i.e. from 05:30
h until 08:30 h as well as from 14:00 h until 22:00 h. For the
weekend, your heating system should provide heat from 08:30 h
until 21:00 h.
HEATING PROG
MON–FRI
HEATING START
HEATING STOP
HEATING CIRC
HEATING START
HEATING STOP
HEATING START
SAT–SUN
HEATING START
HEATING STOP
HEATING START
HEATING START
SAT–SUN
BACK
To Next Page
Loading...
Need help?
General
