OPERATION
Operation
16 | WPF basic www.stiebel-eltron.com
BACK
HEATING PROG
4.5.9 DHW programs
The DHW PROGRAM parameter enables you to select the times
when the appliance will control DHW heating using the set day
value. At all other times, the appliance controls DHW heating using
the set night value. You will have already selected the set values
under system parameter DHW TEMP. bereits eingestellt.
You can adjust your DHW heating as follows:
- for each individual day of the week (Monday, ..., Sunday)
- Monday to Friday (Mo – Fr)
- Saturday and Sunday (Sa – Su)
- the whole week (Mo – Su)
You can adjust three switching time pairs (I, II, III) for each of
these options.
Exception: You will need two switching time pairs, if you want to
heat DHW from 22:00 h until 06:00 h the following day.
Example:
You want to heat up DHW daily at two different times, i.e. from
22:00 h until 06:00 h the following day, and then from 08:00 h
until 09:00 h.
The day begins at 00:00 h; therefore begin programming for this
example at 00:00 h. The first switching times pair runs from 00:00
until 06:00 h. The second switching time pair runs from 08:00
until 09:00 h. The third switching times pair runs from 22:00 h
until 23:59 h.
DHW PROGRAM
MON–SUN
DHW START
DHW STOP
DHW START
DHW STOP
DHW START
DHW STOP
MON–SUN
BACK
DHW PROGRAM
To Next Page
Loading...
Need help?
General
