OPERATION
Operation
www.stiebel-eltron.com WPF basic | 9
4.5.2 Room temperature, heating circuit 2
With menu item ROOM TEMP HC2, you can select the set room
temperature for day and setback mode for heating circuit 2. You
can change the room temperature, if you feel rooms are either
too hot or too cold. ROOM TEMP HC2 will only be displayed if the
mixer flow sensor is connected.
The actual room temperature can also be scanned, as soon as the
FE7 or FEK remote control has been connected and allocated to
heating circuit 2.
ROOM TEMP HC2
SET ROOM T DAY
SET ROOM T DAY
SET ROOM T NGT
SET ROOM T NGT
ACTUAL ROOM T
BACK
ROOM TEMP HC2
4.5.3 DHW temperature
With parameter 9, you can allocate a set day and night tempera-
ture to the temperature inside the DHW cylinder.
DHW TEMP
SET DHW T DAY
SET DHW T DAY
SET DHW T NGT
SET DHW T NGT
ACTUAL DHW T
BACK
DHW TEMP
To Next Page
Loading...
Need help?
General
