Stihl MS 461 - Wiring Harness

101MS 461, MS 461-R
: Fit generator wire (1) in the guide
(arrow) and position snugly
against the crankcase.
: Pass the generator wire (1)
under the wiring harness (2) and
fit it in the guide (arrow) so that
the protective tube lines up with
the guide rib (3).
: Push the insulating tubes (1)
onto the generator wire.
: Connect the pins (2) and
sockets (3) and center the
insulating tubes (1) on the
connectors.
3443RA480 TG
1
3443RA481 TG
1
2
3
3443RA482 TG
1 1
3
2
3
2
: Push the red generator wire (1)
and connector (2) into the guide
(arrows).
: Push the yellow generator
wire (1) and connector (2) into
the guide (arrows) – the red wire
with connector must be laid under
the yellow wire with connector.
3443RA483 TG
1
2
3443RA484 TG
1
2
The wire (1) must be properly
seated in the guide (arrow) and
must not project.
The flywheel must not touch the
generator wire
– this could cause a break in power
supply.
– Install the flywheel, b 7.5
– Install the ignition module, b 7.2
– Reassemble all other parts in the
reverse sequence.
13.8 Wiring Harness
The short circuit wire and the wires
for the heating system form a single
unit.
If one wire is faulty, the wiring
harness must be replaced.
Removal and installation are
described in chapter on "Wiring
Harness, Removing and Installing
on Models with Heating System",
b 7.6.4
3443RA485 TG
1