Stihl MS 461 - 14 Special Servicing Tools

106 MS 461, MS 461-R
14. Special Servicing Tools
New Special Tools
Existing Special Tools
No. Part Name Part No. Application Rem.
1 Piston support 5910 893 5300 Supporting the piston
No. Part Name Part No. Application Rem.
1 Carburetor and engine tester 0000 850 1300 Testing engine and carburetor for leaks
- Nipple 0000 855 9200 Testing carburetor for leaks
- Hose for leakage test 1110 141 8600 Testing carburetor for leaks
- Plug for leakage test 1122 025 2200 Leakage testing decompression valve
2 Sealing plate 0000 855 8106 Testing crankcase for leaks
3 Apply installing tool 0000 890 2201 Installing rope guide bushing
4 Clamping strap 0000 893 2600 Compressing the piston rings
5 Locking strip 0000 893 5903 Blocking the crankshaft
6 Screwdriver bit, T 27 x 125 0812 542 2104 Removing and installing spline socket
screws with electric or pneumatic
screwdrivers; tightening down screws
with torque wrench
7 Assembly drift 1108 893 4700 Removing and installing piston pin
8 Puller 1110 890 4500 Removing flywheel
9 Setting gauge 1111 890 6400 Adjusting air gap between the ignition
module and flywheel
10 Press sleeve 1115 893 4600 Installing oil seal
(ignition side)
11 Assembly tube 1117 890 0900 Attaching springs
12 Press sleeve 1118 893 2401 Installing oil seal
(clutch side)
13 Installing sleeve 1118 893 4602 Protecting the oil seal
(clutch side)
14 Press arbor 1118 893 7200 Installing ball bearing (clutch side)
15 Press arbor 1120 893 7200 Installing ball bearing (ignition side)
16 Combination wrench 1129 890 3401 Spark plug 1)
17 Service tool ZS (set)
including
drilled plate 5910 893 2103
5910 007 2201 Removing and installing
crankshaft (ignition side)
- Drilled plate 5910 893 2101 Pulling two halves of crankcase
together
- Screw sleeve 5910 893 2420 Installing crankshaft