72 MS 461, MS 461-R
: Rotate throttle rod (1)
counterclockwise and disconnect
it from the carburetor's throttle
lever (2).
– Remove throttle lever with
grommet and baffle.
– Check individual parts, replace if
necessary
Installing
: Push angled end (arrow) of
throttle rod (1) through the back
of the grommet (2).
: Push knob (1) into hole in baffle.
1
2
3443RA400 TG3443RA401 TG
12
3443RA402 TG
1
: Fit the baffle (1) with grommet (2)
and throttle rod (3) over the studs
and locate it in position.
: Rotate throttle rod (1) clockwise
to attach it to the lever (arrow) on
the throttle shaft.
: Push the grommet (1) into its
seat (arrow) and locate it in
position.
3443RA403 TG
1
2
3
1
3443RA404 TG3443RA405 TG
1
Check operation
– Open throttle wide and hold
trigger in that position, then
attach throttle rod to trigger – the
trigger may operate only when
the lockout lever is depressed.
– Squeeze trigger all the way, the
throttle lever on the carburetor
must then be in the full throttle
position. It should not be possible
to open it any further.
– Reassemble all other parts in the
reverse sequence.
10.3.1 Throttle Rod on Models
with Heating
– Throttle rod removal and
installation procedures are the
same as for models without
heating, b 10.3
In addition, make sure the insulating
tube (1) locates against the
grommet (2).
– Reassemble all other parts in the
reverse sequence.
3443RA469 TG
1
2
To Next Page
Loading...
