36 MS 461, MS 461-R
– Screw the spindle fully into the
service tool.
: Screw the threaded sleeve (1)
5910 893 2409 onto the spindle
as far as stop
– left-hand thread.
: Apply the screw sleeve to the
crankshaft stub (arrow) and push
the service tool over the bar
studs.
: Hold the crankshaft (1) steady
and rotate the spindle (2) to
screw the threaded sleeve onto
the crankshaft stub.
165RA133 TG
1
3443RA119 TG3443RA120 TG
2
1
– Release the crankshaft (1). Hold
the service tool steady and
continue turning the spindle (2)
until the tool butts against the
crankcase.
– Fit the nuts on the collar studs
and screw them down finger-
tight.
: Turn the spindle (2)
counterclockwise until the
crankcase locates against the
guide sleeves.
Make sure the sleeves (arrows)
engage the holes and the gasket is
not pinched or twisted.
– Continue turning the service
tool's spindle until the gap
between the two halves of the
crankcase is closed.
– Unscrew the mounting nuts.
– Unscrew the spindle clockwise
and take away the service tool.
– Take out the M5x72 screws.
3443RA117 TG
: Insert the screws (arrows) and
tighten them down firmly in a
crosswise pattern.
– Install the oil seals, b 6.3
– Install the circlip.
– Check and install the piston,
b 6.7
– Check and install the cylinder,
b 6.5
– Reassemble all other parts in the
reverse sequence.
3443RA103 TG
To Next Page
Loading...
