Stihl MS 461 - Page 63

62 MS 461, MS 461-R
– Use STIHL press fluid to make
installation easier, b 15
: Push the hose (1) onto the
sleeve (2) as far as stop.
– Position the tank housing against
the annular buffer – the holes
must line up.
: Push sleeve (1) with hose into
the annular buffer, fit the
screw (2) and tighten it down
firmly.
– Reassemble all other parts in the
reverse sequence.
3443RA331 TG
2 1
3443RA332 TG
2
1
9.1.2 Annular Buffer on Spiked
Bumper / Clutch Side
: Take out the screw (1) and
remove the side plate (2).
: Take out the screw (3) and
remove the chain catcher (4).
: Pry out the plug (1).
: Take out the screw (1) and pry
out the annular buffer (2).
– Check the buffer and replace it if
necessary.
3443RA333 TG
2
1
4
3
3443RA335 TG
1
3443RA336 TG
1 2
: Pull the rubber ring (1) off the
tank housing stub and push it out
through the crankcase bore
(arrow).
– Inspect the rubber ring and
replace if necessary.
Installing
– Use STIHL press fluid to make
installation easier, b 15
: Push the rubber ring (1) through
the crankcase bore (arrow) and
onto the tank housing stub until it
is properly seated.
The rubber ring must not be pinched
between the annular buffer and tank
housing.
3443RA338 TG
1
3443RA338 TG
1