Stonex S980A GNSS Receiver – User Manual v1.0
18
2.5.2 Base
Base mode, additionally to the rover configuration, has some specific
parameters to se a base. For example you can set data type, start base, base
position and so on.
Important parameters are the position of the base. User can set as Base
position Single, if the position of the base is unknown or type directly the
coordinates of the base point selecting Repeat Position.
If you select UHF mode, most of the settings are the same as in rover
configuration. In addition you can set the radio power. To obtain the best
performance it is suggested to set HIGH.
If you select Network, as in the rover mode, is possible to set the data type,
site ID, base position and record raw data, APN account, APN user and
password, connect mode, caster address and port. Furthermore, the
parameters of the coordinates of the base can be set.
To Next Page
Loading...
