Stonex S980A GNSS Receiver – User Manual v1.0
36
In the same screen, it is possible to ask the software to show on screen the
angle of the tilt angle (in decimal degrees, 0° = true vertical).
To show this information, flag the relative check box inside the Sensor Option
menu.
The user can also define the verticality tolerance of the instrument.
It means, the maximum value of the (sensor) tilt angle that the software shall
accept when checking for the pole verticality.
The value is in decimal degrees.
Example: 0.3 means +/- 0.3° from true (local) verticality.
To Next Page
Loading...
