Strand 200 Console Manual Page 13
Operation
Single Scene Mode
Basic Operation
First, make sure the console is in single scene mode by identifying the
scene mode LED indicator. The LED below single scene will be lit. If not,
toggle the scene mode button until the proper LED is glowing.
Adjust the preset A master to full (UP) and the preset B
master to 0 (UP)
Note: Preset master levels will be shown on the LCD screen.
Make sure the grand master is at full.
Provide level to any combination of faders.
This will bring up each dimmer on a one to
one basis with the fader for the number of
faders on your console. (i.e. fader 1 brings
up dimmer 1, fader 15 brings up dimmer 15)
If this is the 12/24 model, the operator has
control of 24 faders. If this is the 24/48
model, the operator has control of 48 faders.
See the Patch section to change the dimmer assignment.
To Next Page
Loading...
