Strand Lighting 200 Console - Console Self-Test Diagnostics; Running Diagnostic Tests

Strand 200 Console Manual Page 35
1. Patch
2. Self Test
3. Midi
Esc Next Confirm
1. All test
2. Display test
3. fader test
Esc Next Confirm
4. Key test
Esc Next Confirm
Self Test
Self Test is a set of on-board diagnostics that will check for problems in all areas of the
console.
Notice the cursor flashing over the 1 for patch.
Press the right arrow key to access self test then
press F3 to Confirm.
1. This will test all of the following items.
2. This will test the display functions on the console.
3. This will test all faders on the console.
4. This will test all buttons on the console.
Follow all prompts on screen to complete the self
tests. For the fader test, activate all faders to full as the screen prompts for each one.
For key test, press all buttons as the screen prompts for them.
Any errors should be reported to your local Strand Distributor, Authorized Service Centre or
Strand representative.