Strand 200 Console Manual Page 9
Quick Guide
1. Grand Master– an inhibitive fader that proportionately controls all other level faders. This
determines maximum output of all faders at all times. The master is always active.
2. Mode Button - toggles the console between the 3 different modes; submaster mode, two
scene mode and single scene mode. The LED will show current mode.
3. Navigation Keys– these keys allow for navigating within the LCD screen.
4. Function Keys – these keys allow access to all scene, effect and setup change functions.
F1 – the function of this key will be displayed at the bottom left of the LCD screen. It
allows the operator to go back a screen.
F2 – the function of this key will be displayed at the bottom center of the LCD screen.
It allows the operator to advance screens within a function.
F3 – the function of this key will be displayed at the bottom right of the LCD screen. It
allows the operator to confirm an operation.
5. Blackout Button– when pressed, all levels go to zero. (The flashing LED above the
button will indicate this) Press again, and all levels will return.
6. LCD Screen – displays current information about the console’s status.
7. Record Button – allows recording of levels of faders. When pressed, the LED above will
flash indicating the console is in record mode.
8. Step Rate Fader – changes rate of effect steps according to level. The range is from
0.05 seconds to 10 seconds with manual being at zero.
9. Hold Button – this button will freeze the output of the faders so that the operator can
reset the channel faders for a different look or cue. This feature only works in one scene
mode.
10. Split Time Faders – allows the operator to set a timed fade for the levels going up (IN)
and a different timed fade for the levels going down (OUT). The range is from manual to 15
minutes.
11. Channel LED Indicators – each fader has one and it will glow in proportion with the
fader level.
12. Scene A Faders –
Submaster mode – all faders are submasters and not controlled by Preset A.
Two scene mode - top row of faders are mastered by Preset A.
One Scene mode – all faders are mastered by Preset A.
To Next Page
Loading...
