Strand Lighting 200 Console - Patching DMX Addresses; Edit Patch Settings via Command Line

Page 32 Strand 200 Console Manual
1. Patch
2. Self Test
3. Midi
Esc Next Confirm
Scene Pg: 1 Fx Pg: 2
Preset A: FL B: 00
Scene FX Setup
1. Edit patch
2. Display patch
3. Default patch
Esc Next Confirm
Cmd:_____________________
_
________________________
_
________________________
Esc
Setup
The following is all of the options that can be
accessed through the setup menu.
Press F3 to go into the Setup menu.
Patch
Patch allows you to assign any DMX output address(es) to any channel.
Notice the cursor flashing over the 1 for patch.
Press F3 to Confirm.
Each of the four options will continue their key sequences from this point. Repeat above for
each option below.
Note: The Next command allows the operator to access any option above the third option.
Edit Patch
The console defaults to a one to one patch. This function allows the operator to edit this to
any combination in a command line input format.
Notice the cursor flashing over the 1 for edit patch.
Press F3 to Confirm.
The Num lock LED will now be on and the effect
disabled. The LCD displays an empty command line.
Type in the patch information using the following
format:
Dimmer @ Channel.
For example…for dimmer (output) 12 to be patched to channel 3 then type…
12 @ 3 ENTER *
Note: On consoles that use command lines, the typical key for enter is the asterisk * key. Here that is
the FX Page key with Num Lock enabled.