Page 28 Strand 200 Console Manual
Scene Pg: 1 Fx Pg: 2
Preset A: FL B: 00
Scene FX Setup
1. Edit Effect
2. Delete Effect
3. Effect Fade Time
Esc Confirm
Effect
3. Edit fade time
4. Set fade time to 0
Esc Confirm
Page: #
Effect: #
Fade time: 00.0 sec
Esc (+/-) Confirm
Effect
1. Edit fade time
2. Set fade time to 0
Esc Confirm
Reset effect fade
time to
0.0 sec?
Yes No
Effect Fade Time Options
From the main LCD screen, press F2 for FX.
Notice the cursor flashing over the 1 for edit effect.
Press the right arrow to select the effect fade time
option. Press F3 to Confirm.
Each of the two options will continue their key sequences from this point. Repeat above for
each option below.
Editing Effect Fade Time
Effect fade in time can be set between 0-10 seconds using the edit fade time function. Effect
fade in time will be defaulted at zero when record. Fade out time is not available, an effect
will stop immediately when deactivated.
Press Confirm to edit the fade time.
Num lock LED will now be on and the effect disabled.
Pick the effect page then scroll with the arrow keys to
place the cursor on the effect number. Select the
effect to be edited. Scroll to edit the fade time. The
range is from 00.0 to 10.0 at 1/10
th
second increments.
Reset Effect Fade Time to Zero
Press the right arrow to select the second option
and press Confirm to set the fade time to zero.
Select Yes or No.
To Next Page
Loading...
