Stratasys Objet24 V2 - Server Workstation

Objet Desktop 3-D Printer Site Preparation Guide
DOC-04002 15 Rev. D2
5.4 Server Workstation
Thecustomermustprovideacomputerfortheserverworkstation,with
thefollowingminimumrequirements:
Other Requirements
•TheserverworkstationmusthaveauserwithAdministrator
privileges.
•Noadditionalprograms(includingantivirussoftware)shouldbe
install
edontheserverworkstation.
Itisrecomme
ndedthattheserverworks
tationbeconnectedtothe
customer’sLANbeforeprinterinstallation.
Processor
Single Processor Pentium
®
4, 3.0 GHz; 512 KB cache
memory
Operating System
• Microsoft Windows XP
®
Professional (32 Bit only)
with Service Pack 2
• Microsoft Vista
®
• Microsoft Windows 7—Professional, Ultimate and
Enterprise versions only
Macintosh operating systems are not supported.
Graphics Card
Supporting Open GL; 512 MB of memory
See recommendations below.
Memory 4 GB RAM
Mouse and Keyboard USB type (at least 101/102-key keyboard)
CD/DVD ROM Drive IDE CD/DVD ROM Drive
Hard-Disk Drive 40 GB
Network Card Two 10/100 Mbps network cards
Table 6: Server workstation requirements
The above table lists the minimum hardware requirements for the server
workstation. The customer can use a computer with a faster and more powerful
processor, increased RAM and hard disk size, etc.
You control both the built-in printer computer and the server workstation with same
keyboard-monitor-mouse set by using a KVM switchbox. The switchbox is
provided in the printer Start-up Kit.