Stratasys Objet24 V2 - Client Workstations; Network; Heat Dissipation

Objet Desktop 3-D Printer Site Preparation Guide
DOC-04002 16 Rev. D2
5.5 Client Workstations
Theserverworkstationspecifications(listedinTable6)arerelevantforall
CADandremoteclientworkst
ationsthatsendmodelstotheprinter,with
theexceptionofthefollowing:
•Clientworkstati
onsrequireaminimumof2GBRAM.
•Clientworkstati
onsdonotrequireaUSBconnectiononthemouse
andkeyboard.
5.6 Network
Anetworkconnectionisrequiredneartheserverworkstation.
Figure 5–1 Network connection
5.7 Heat Dissipation
Table7describestheheatdissipationofthesystemunits.
Objet 3-D
printing
system
Crossed Network Cable
5 m (16' 5")
Point-to-Point To local network
Server
Workstation
Printer
computer
The printing system enables printing from all workstations connected to the
customer’s network. Therefore, during the site preparation, identify all such
workstations to ensure that each has the correct operating system and computer
specifications.
Unit Estimated Heat Dissipation
Printer 760 W (2600 BTU)
Server workstation 450 W (1530 BTU)
Table 7: Heat dissipation per unit