8 STRATASYS / THE 3D PRINTING SOLUTIONS COMPANY8 STRATASYS / THE 3D PRINTING SOLUTIONS COMPANY
Wizards
Description
Head Alignment
This wizard checks the alignment of the print heads and updates the parameters if
necessary.
Head Cleaning
This wizard adjusts the print block and the tray to enable you to
clean the print heads
Heads Optimization
This wizard test the print heads and calibrate them to the best working
configuration possible to maintain optimum printing.
Load Cell Calibration
This wizard calibrate the Load Cells in the drawer that measure the weight of the
cartridges and the waste container.
Material Flush/Fill Wizard
• Use this wizard if you need to shut down the printer for more than one week.
• This wizard replaces printing materials in the tubes & print heads with
cleaning fluid.
ReInitiate
This wizard runs automatically when needed, as part of the Pre-Print mode (before
printing begins).
It’s purpose is to drain existing materials in tubes since the viscosity changes over
time and may cause quality issues.
To Next Page
Loading...
