25 STRATASYS / THE 3D PRINTING SOLUTIONS COMPANY
Procedure
1. Turn on the main power switch on the front panel of the WaterJet
2. Open the WaterJet cabinet side door.
3. Place a model in the WaterJet cabinet.
4. Close the side door.
5. Insert your hands in the built‐in gloves.
6. Select a suitable cleaning nozzle.
7. Activate the WaterJet using the foot pedal
8. When you have finished removing the support material, open the side door and remove the model.
9. If there are no more models to be cleaned at this time, switch off the WaterJet.
10. Turn off the water supply to the WaterJet.
Operating the WaterJet
To Next Page
Loading...
