26 STRATASYS / THE 3D PRINTING SOLUTIONS COMPANY
General Guidelines
• Always open the water supply source (tap) before activating the Objet WaterJet.
• Do NOT open the side door of the WaterJet cabinet while it is working and do NOT operate the WaterJet cabinet
while the door is open.
• The water tap/supply MUST remain open when the WaterJet is activated to prevent damage to the pressure
pump.
• The water pressure pump requires a water supply pressure of at least 1 atm.
• Always turn off the water supply source after use.
Operating the WaterJet
To Next Page
Loading...
