Step 5: Draw the blind spot area into a rectangle by moving four points (the drawn
area shall cover all the blind spots in front of the vehicle).
Click Save to complete the calibration.
6.2.4 Principle of Actual Vehicle Routing
1. If the front end shall not be perforated, it is suggested to install the camera on
the cargo box or the connector.
2. If the vehicle is equipped with a self-unloading carriage, and the camera must
be installed on the carriage, the blind spot of the top view should be routed
from the trail to the front end.
3. The side-mounted BSD is not applicable to trailers, and the routing to the
trailer is not practicable.
7. Acceptance and Cleaning
7.1 Cleaning
Clean up the installation site, collect and take away tools and waste separately, and
put the original articles in the vehicle to their original place, and then the installation
work ends.
To Next Page
Loading...