Need help?Do you have a question about the Streamax AD Plus and is the answer not in the manual?
Overview of the AD Plus DVR, its features, and applications.
Diagram showing system connection using OBD interface for power supply.
Diagram illustrating system connection using discrete wires for power supply.
Outlines technical prerequisites and knowledge for personnel performing the installation.
Emphasizes the need to understand vehicle specifics for successful installation.
Details checks for vehicle readiness and electrical system integrity before installation.
Describes the two methods for connecting the AD Plus to the vehicle's power supply.
Guide for verifying the DVR and accessories after unpacking.
Details signal cable connections required for intelligent assisted driving functions.
Lists the necessary tools and accessories for the installation process.
Detailed table of tools and their purposes for installation.
Step-by-step guide for inserting the SIM and Micro SD cards into the main unit.
Lists specific tools required for installing the DMS camera.
Specifies requirements for optimal placement of the DVR on the front windshield.
Instructions for cleaning the glass and preparing for bracket mounting.
Details on using a level to ensure horizontal bracket placement on the windshield.
Steps for attaching the DVR unit to the previously mounted bracket.
Guide for adjusting the DVR's vertical position using a level and securing it.
Details on connecting the device to the vehicle's power source.
Instructions for connecting signal cables and managing wiring.
Describes connecting power via the vehicle's OBD interface.
Explains connecting power using discrete wires and relevant pin definitions.
How to connect vehicle speed pulse or CAN data cables for speed information.
General instructions for connecting various signal cables like speed, steering, and reversing.
Connecting speed signals via pulse or OBD, including pin definitions.
Locating and connecting steering and reversing signal cables.
Instructions for arranging and concealing cables within the vehicle's interior trims.
Guidelines for selecting and fixing the location of the power supply box.
Steps to connect the ADPlus device to the Veyes APP for configuration.
How to measure vertical height and horizontal distance for ADAS camera calibration.
Inputting measured parameters like height, margin, width, and length in the APP.
Steps for initiating and performing automatic ADAS calibration via the APP.
Configuring the steering wheel position (left or right rudder) in the Veyes interface.
Adjusting the internal cab camera angle for optimal viewing of the driver.
Introduction to the different types of externally connected DMS cameras available.
Guidelines for placing the DMS camera on the A-pillar or other locations.
How to adjust the DMS camera angle for proper driver face and seat belt visibility.
Specific mounting details for A-pillar and countertop DMS camera installations.
Step-by-step guide for installing the A-pillar mounted DMS camera.
Procedure for installing the DMS camera using a glass mounting bracket.
Guidelines for installing the countertop DMS camera above the instrument panel.
Steps to initiate DMS camera calibration within the Veyes APP.
Selecting the correct installation location type for DMS camera calibration.
Installing and calibrating top view cameras for blind spot detection.
Procedure for calibrating BSD cameras installed on the left and right sides.
Steps to calibrate the blind spot detection for front top view cameras.
Guidelines for routing cables based on vehicle type and camera placement.
Instructions for cleaning the installation area and removing tools and waste.
Final checks and documentation required for installation acceptance and sign-off.
General| Brand | Streamax |
|---|---|
| Model | AD Plus |
| Category | Dash Cameras |
| Language | English |
To Next Page
