in the DMS video screen that will obstruct the driver's face and the seat
belt features.
4. Tighten the screws on the right side of DMS camera bracket to ensure that the
camera will not shake.
6.1.4.3 Installation Requirements for CA29M Camera Vertically Mounted on
Countertop
If the DMS camera is a countertop-mounted CA29M, the CA29M camera needs to
be fixed above the instrument panel. The specific installation method is as follows:
1. Power on the device first; then, connect with the device through the APP, enter
the real-time preview screen, and preliminarily determine the camera
installation location which shall meet the following requirements:
(1) The desktop is flat and the camera can be fixed easily.
(2) The driver's face on the DMS screen is not obstructed by the steering
wheel, and the upper part of the driver's body (above the chest) can be
displayed on the screen. It shall be ensured that the seat belt features and
face features can be seen, and the driver's face appears in the middle of
the screen.
(3) DMS camera should be fixed in the middle of instrument panel. If this is
not possible, the camera can be installed with rightward or leftward
deflection, but the maximum deflection angle shall not exceed 30°.
2. After the installation position is determined, fix the DMS camera bracket on
the instrument panel with self-tapping screws.
3. After the base is fixed, adjust the angle of DMS camera lens to ensure that the
following requirements can be met according to the normal driving habits and
sitting posture of the driver:
(1) Make sure that the driver's face appears in the middle of the video screen,
the driver's face and body are vertical on the video screen, and the lower
edge of the screen is below the driver's chest.
(2) Make sure that the fill light of the DMS camera illuminates the driver's
face (fill light illuminating the seat belt is not allowed; otherwise, it will
lead to overexposure of video).
(3) Make sure that there is no other object (for example, the steering wheel)
in the DMS video screen that will obstruct the driver's face and the seat
belt features.
4. Tighten the screws of DMS camera bracket to ensure that the camera will not
shake.
6.1.5 Calibration Requirements
Log in to the Veyes APP.
1. Click Preview on the homepage to enter the preview interface.
Double-click the driver channel to enter the main-stream full screen.
2. Click AI Calibration for calibration selection.
To Next Page
Loading...