Strong SRT 7004 - Connecting multiple fixed LNBs using a DiSEqC 1.0;1.1 switch; Connecting to Ethernet; FIRST TIME INSTALLATION

3.3 Connecting multiple xed LNBs using a DiSEqC 1.0/1.1
switch
Fig. 8
a.: Connect the LNBs of your fixed antenna to the inputs of a DiSEqC 1.0/1.1 switch
b.: Connect the output or “to receiver” connector of the DiSEqC 1.0/1.1 switch to the SAT IN
connector on your receiver.
c.: Refer to section 3.1 or 3.2 for TV and mains connections.
d.: Refer to section 7.1.1 for Satellite Settings
3.4 Connecting to Ethernet
Fig. 8
Connect a CAT5 cable (or higher quality) to the RJ45 connector of the unit and the other end to an
existing switch, router or modem. The default setting is Auto (DHCP) for automatically obtaining IPs
and DNS. Select Manual in Menu NetworkNetwork Settings to enter own settings if required. When
setting up manually, you need to provide a unique IP address, Netmask, Gateway and DNS for
your receiver. Refer to the manual of your router or modem to setup properly. The Ping test can be
selected to check your connecting, once setup correctly.
4.0 FIRST TIME INSTALLATION
After all connections have been made properly, switch on your TV and make sure the receiver is
connected to the main power. If you are using the receiver for the first time or restored to factory
default, the Installation menu will appear on your TV screen. Press the tu buttons to select the OSD
Language of your preference.
Country Select your country.
Pre-installed List Some countries come with a pre-installed channel list.
If not available for your country, the item is not selectable.
Video Output Select the output you prefer to use.
TV Format Select between 16:9FIT. 16:9LB and 4:3LB or 4:3PS
Start Search If the pre-installed list is selected, the receiver will jump to the first channel in
the list. If no pre-installed list available, the Satellite Setting page will appear.
NOTE: If Germany is selected as country, a German pre-set channels list from
ASTRA 19.2E will be installed. The pre-installed list will work with a single
Universal LNB (LO 9750/10600). If another type of LNB is used, you need to
setup the LNB in the Installation Menu, Satellite Setting.
You can continue with the Installation menu to scan and install further channels as described below
or go to viewing mode by pressing the EXIT button to start enjoying the pre-installed channels
immediately.
8
PART 2 • English