6.7 Favourite channels
Press the FAV button to access your favourite channels and to toggle between available favourite
groups. Please refer to section 7.2.1 for details on how to create favourite lists.
6.8 Instant Recording*
Your new receiver allows you to make an instant recording of the programme you are watching.
Simply press 4 and confirm with OK to start the recording. Default recording time is set to 2:00 hours.
If you like to change the duration time of a recording, press 4 and select the duration with tu.
During the recording a recording sign will be shown in the channel list. To stop the recording, press 3
and press OK again to stop the recording.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR
software has not yet been installed.
**Please connect a USB storage device with sufficient free space before you start a recording.
6.9 Timeshift*
Timeshift allows pausing live broadcasts and resume playback later. Press 2 in viewing mode to
activate Timeshift, according the set Timeshift mode in the menu. A time banner and pause symbol
will appear on screen. Live TV is now frozen. Press 2 to resume timeshifted playback. Press 5/FF for
fast rewind/fast forward. Press 3 to return to live TV.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR
software has not yet been installed.
7.0 MAIN MENU
The Main Menu consists of the following items: Installation, Channel, Multimedia, System, Others and
Network.
7.1 Installation
This menu consists of the following items: Satellite Setting, Automatic SAT Scan, Manual Scan,
Information. Press the MENU button and tu pq to navigate through the menu.
7.1.1 Satellite Setting
Press the pq buttons to highlight the satellite your dish is aimed at. Its antenna settings will be
shown at the right side. You can enter the right side with the tu buttons and return to the satellite
list with EXIT. From the Satellite Setting menu, you can start a scan by pressing the GREEN button
after you have made the appropriate settings or edit transponders by pressing the RED button.
7.1.2 Congure the antenna settings for the selected satellite
Satellite The name of the selected satellite is shown here.
LNB The setting is Universal LNB (09750/10600) – the most used on the market.
Transponder Select a transponder, known to carry a signal.
DiSEqC 1.0 Select the switch type in use. 4 to 1(DiSEqC 1.0) or 16 to 1. (DiSEqC 1.1) Select
Tone Burst if a Legacy 2to1 switch is used.
Uncommitted If uncommitted DiSEqC switches are used, select them here. (Advanced user
setup)
12
PART 2 • English
To Next Page
Loading...
