EasyManua.ls Logo

Strong SRT 7004 - TROUBLESHOOTING

Strong SRT 7004
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
starts to timeshift the currently watched programme. In the Timeshifted content you can use 56, 1
to view the earlier parts of the programme or to return to the actual point.
OFF: The Timeshift function disabled.
One button recording: OFF, ON. With tu you can switch ON/OFF the one button recording mode.
ON: If the 4 button is pressed in the one button recording mode the recording
starts and are processed in the menu set recording length time. OFF: After
pressing 4 the recording length time window appears on screen. With tu
(15 min steps) and pq (1 hour steps), you can setup the recording length
time and then press 4 again. During the recording you can change the
recording length time by pressing 4.
Default Recording Period:
You can setup the default recording time period by pressing tu.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR
software has not yet been installed.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Please check the receiver
according to the procedures shown below. If the receiver does not work properly after checking
it, please contact your local Service line or a STRONG dealer. Alternatively you can send a support
mail via our website: www.strong.tv. NEVER open or disassemble your receiver. This may cause a
dangerous situation and will void the warranty.
Problem Possible cause What to do
The display on the front panel
does not light up.
Mains cable is not connected
Mains fuse blown
Check that the mains cable is
plugged into the power socket
Check mains fuse
No sound or picture,
but the front panel shows
red light
The receiver is in standby
mode
Press the On/Standby button
No sound or picture, but the
receiver menu can be seen on
TV screen.
(press ‘menu’ on remote)
Channel is off-air
The satellite dish is not
pointing at the (correct)
satellite.
Channels deleted in edit
menu
Try other channel(s).
Check the signal level in the
Antenna Setup menu. Adjust
the dish.
Scan for channels (again)
26
PART 2 • English

Related product manuals