Scan Select: Select All Sat to search all satellites you have selected in the Satellite Setting
menu. Select Single Sat to search only the satellite selected under Satellite.
After configuring, press GREEN to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown
on screen. During the channel search you can quit the scan process with EXIT or MENU. When the
progress has been completed, all found channels will be stored and the receiver will switch to the first
found channel.
7.1.5 Manual scan - Scanning by transponder
Select the options if you want to do a manual scan. (Advanced users.)
Satellite: Select the satellite you wish to scan from, as previously set up in the Satellite
Setting menu.
Frequency: Enter a known frequency of a satellite transponder with the 0 ~ 9 buttons on
the remote.
Symbol Rate: Enter the symbol rate of the previously set satellite transponder with the 0 ~
9 buttons on the remote.
Polarity: Set the polarization of the previously set satellite transponder, V (Vertical) or
H (Horizontal).
NIT: Select On if you want to do a scan starting from the previously set satellite
transponder according to the Network Information Table, as offered by the
Satellite Provider. Select Off, to scan just the one transponder.
Programme: Select Free Only to search for Free to Air channels. Select All to include
scrambled channels as well. Note: Scrambled channels cannot be watched
with this receiver.
After configuring, press GREEN to start scanning with the selected settings.
Your receiver will now perform a channel search with the scanning progress shown on screen. During
the channel search you can quit the scan process by pressing EXIT or MENU. When the progress has
been completed, all found channels will be stored and the receiver will switch to channel number 1.
The new found channels are added to the end of the list.
Satellite Finder: You can use the menus Satellite Setting, Automatic Sat Scan or Manual Scan to
find a satellite and peak the dish for maximum reception. Select the satellite
you wish to find or peak, select the settings according to your dish-setup and
then select a transponder which is known to carry a signal. Use the signal and
quality bar to find/peak the satellite. Signal strength and quality above ~70%
would be considered usable.
7.1.6 Information
Find technical information about this receiver as model, hardware and software versions. This
information might be asked for if you contact us.
7.2 Channel
Press MENU and select Channel by pressing the tu buttons. Use the pq buttons to select the TV
Channel Editor submenu. Press OK to edit programme settings. Press EXIT to exit the menu.
15
To Next Page
Loading...
