Strong SRT 7004 - Automatic SAT scan

a new Transponder. In the popup window enter the frequency, symbol rate
and polarity of the new transponder.
Delete While in the satellite name list: Press BLUE to delete a satellite from the
list. Press GREEN to delete the selected satellite, select YELLOW to delete
all satellites. Confirm deleting with OK or EXIT to cancel. While in the
Transponder list: Press BLUE to delete a transponder from the list. Press
GREEN to delete the selected transponder, select YELLOW to delete all
transponders. Confirm deleting with OK or EXIT to cancel.
Edit: While in the satellite name list: Press RED Edit to enter the Sat Edit window.
Select the satellites position E for East and W for West. Longitude: Use the
numeric keys to enter the longitude of the satellite. Enter a satellite name
with the key table (press u), selecting a character by using the navigation
buttons. Press OK to enter the chosen character. When you have entered the
name, navigate to the “floppy disk-symbol” on screen and press OK on the
remote control to confirm the new name. Save the settings with OK or cancel
by EXIT. While in the Transponder list: Press RED Edit to enter the TP Edit
window.
Frequency: Use the numeric keys to enter a known frequency of the satellite transponder.
Symbol Rate: Use the 0 ~ 9 buttons to enter the symbol rate of the satellite
transponder.
Polarity: Press tu to select the polarization of the satellite transponder. V (Vertical) or
H (Horizontal).
After entering all data, press OK and confirm with OK or press EXIT to leave without saving.
Use GREEN to enter to the Automatic scan window.
Note Deleted satellites and transponders from the pre-installed lists can only be
retrieved by performing a factory reset.
7.1.4 Automatic SAT scan
Select the options if you want to do automatic scan.
Satellite: Select the satellite you wish to scan, as previously set up in the Satellite Setting
menu.
Transponder: Select a transponder which is known to carry a signal to check if reception of
the satellite is possible.
NIT: Network Information Table. If selected On, the receiver will use the NIT
provided by the satellite provider to search for channels. If selected Off, the
receiver will search with its pre-installed transponder list.
Programme: Select Free Only to search for Free to Air channels. Select All to include
scrambled channels as well. Note: Scrambled channels cannot be watched
with this receiver.
Scan Mode: Default TP: All stored transponders in the memory will be scanned.
Blind: Slow scan in 2 MHz steps. The receiver will first scan the whole frequency
band to find the transponders it can lock on. After gathering all transponders,
it scans the transponders one by one to get all available programmes.
One TP: The transponder selected under Transponder will only be scanned.
14
PART 2 • English