the set age, the programme will only be viewable when the correct password
is entered. The options are 4 to 18, no block, total block.
Change Password Press OK, enter the old password, then enter the new password, and confirm
the new password. Memorize it well.
7.2.5.7 Update & Backup
Select System then Update & Backup from the main menu and press OK to select.
Image upgrade
NOTE: The front panel USB port is especially adapted for Software update.
The upgrade can be performed with an USB device, preferably an USB pen drive.
The USB device must have been formatted in FAT32.
Download the required update file for your receiver model from the support page on our website
www.strong.tv or contact your local dealer.
Unzip the file on your computer, if necessary, and then copy it to root folder of your USB storage
device.
Connect the USB storage device to the front USB port of the receiver. Press MENU and select System
then Update & Backup and Image Upgrade. Select the correct USB device (USB0 or USB1). Press OK
to enter the software file list. Select the file containing the software image with pqtu and press
OK to initiate the software update. An attention banner will now be displayed. Press OK to start the
update (or EXIT to cancel it). Follow the instructions displayed on screen. The update process will take
some time. After the update process has been completed the receiver will reboot and the receiver
will start with the last shown channel.
You also can reload your previous backed up channel a favourite database, see Image backup.
WARNING NEVER power off the receiver or remove the USB device during the
software update process. Doing so might cause irreparable damage to
your receiver and will void your warranty.
Image Backup
NOTE: The front panel USB port is especially adapted for Image backup.
This menu allows you to save the channel data base with favourites, the application or backup all
(select it in the top line) of your receiver to a USB device. This very convenient feature enables you
to save your personal settings like Channel and Favourite-lists on an USB storage device and load
them back to the receiver later. This feature is especially helpful after unintentional changes or factory
reset. In such cases just skip the Installation by pressing EXIT in Installation and select the database
management menu in System, Update&backup.
7.2.5.8 Factory setting
Reset your receiver to the default factory settings. Sometimes useful if the unit suddenly behaves in
an unexpected manner, e.g. after a power failure.
21
To Next Page
Loading...
