The menu provides the Multimedia feature for playback of Movie, Music and Photo. The different file
formats listed below are supported. In this menu you can make video and photo configurations. The
unit supports USB devices with FAT32 format. Make sure your USB device is formatted correctly.
NOTE: STRONG cannot guarantee compatibility (operation and/or bus power)
with all USB mass storage devices and assumes no responsibility for
any loss of data that may occur when connected to this unit. With large
amounts of data, it may take longer for the system to read the contents
of a USB device. Some USB devices may not be properly recognized. Even
when they are in a supported format, some files may not play or display
depending on the content. It is possible to use already by PC formatted
NTFS HDDs.
7.3.1 Multimedia*
If there is no USB device plugged in, a warning message ‘Device is not available’ will be displayed.
When a USB device is detected you can select between Movie, Music and Photo in this menu. Select
one of them, press OK to enter the file browser and select the file you want to play.
Movie: Video files in various formats are supported (MPG, MPEG, TS, VOB, MP4,
AVI, ...)**
Music: Supported file formats are MP3 and WMA**
Photo: Supported file formats are JPG and BMP**
My Recorder: Manage your made recordings.
Recorder Settings: Manage your settings for Timeshift and recordings.
Also available item in the menu is: Remove Device.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR
software has not yet been installed.
**STRONG cannot guarantee the playback of files although extensions are listed here, as the correct playback depends on
codec used, data bit rate and resolution as well. Please consult the STRONG Hotline in your country to get more details.
7.3.1.1 Movie
In the Movie menu you have to navigate to a movie file.
Select the file and press OK to start playback in preview mode.
Select ‘Upper Folder’ to go back to the parent folder.
During playback you can use the playback control buttons, such as 1, 2, 3, 5 6, 7 8. You can
check the file details by pressing the button in full screen mode. To close the banner, press again.
Press the GOTO button and enter the time moment you want to jump to with the 0~9 buttons, then
press OK to confirm. With the 5 6 buttons you can rewind or forward playback in x2, x4, x8, x16 and
x32 speed. When it has fast rewound to the beginning, playback of the current file will be resumed.
When it has fast forwarded to the end, playback of the next file starts. With the 7 8 buttons you can
jump to the previous/next video file. Press GREEN to select the correct character set for subtitle files.
Movie Subtitle
This subtitle function is only relevant in the Movie menu for movies which contain subtitle files in .srt
format.
23
To Next Page
Loading...
