3.4 Connecting a USB storage device
Fig.7
This port can be used for USB storage devices such as USB pen drives or HDD with a maximum peak
current of 500 mA. It is recommended to use USB 2.0 storage devices for playback of video les or HD
movies.
3.5 Connecting to Ethernet for RSS feeds and weather forecasts
Fig.8
To use this option of your receiver it must be connected to your router. Connect the Ethernet (RJ-45)
connector with a class CAT5E (or higher) cable to your router.
3.6 Connection to main power supply
Fig.8
After all the connections are done you can connect your digital receiver to the mains power.
3.7 Extended connections for your home entertainment
Fig.9
Connecting to a digital audio amplier and TV using HDMI
By connecting your receiver to an HDMI equipped digital amplier or home cinema set you will enjoy
the best possible sound quality and multi-channel audio (depending on broadcast). Connect the HDMI
output of the unit to an input of your amplier, and then connect the HDMI output of the amplier to
your TV set. Select the correct input on your amplier to watch and listen to programs.
4.0 STARTING UP FOR THE FIRST TIME
When you use your receiver for the rst time, the Welcome menu appears.
In this menu you need to select the rst important settings as “Region” where receiver is used, the
“Language” you like to use in menu and if using active antenna which need “Antenna Power” to function.
Use tu to select and use pq to move the highlight to next item in the menu. Once you have done
these selections, select “Search” and press OK button to start scanning.
The following settings are available:
Region: Select the region in which the receiver is used. The selections England,
Hungary, Poland, Denmark, Italy and France will store channels in Logical
Channel numbering (LCN). This means that it is operator dened which
channel will be stored on position 1 and so on. Sorting of channels afterwards
is not possible. If you like to sort the channels yourself, set the region/country
to Other.
Language: Select the language you like to use in menu or from region where receiver
is used. The audio channels will set automatically to this selection as rst
priority.
Antenna Power: Set to On if you use an active antenna (with built-in amplier). When set to
On, 5 V will be present at the ANT IN connector of the receiver. Select O for
passive antennas.
7
English