Name: Strong SRT 8215
Brand: Strong
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Scan mode: Select All to store scrambled and free-to-air channels or select Free to store

only free-to-air channels.

NOTE: Wrong region selection can lead to missing channels or channels being

stored at wrong positions in the channel list. Scrambled channels cannot be

viewed with this model.

The receiver will search for all available channels. When the scan is nished, the receiver switches to

viewing mode. Now you can enjoy watching your favourite TV channels. If you get the message “No

channels found”, then check again the antenna, coaxial cable, connector and in menu if you have

reception. When this has been checked, reset the unit and follow the installation wizard again as shown

below.

NOTE: If the Welcome menu does not appear after switching on the receiver for the

rst time, reset the receiver to factory settings by pressing the MENU button

and select Factory Setting in the menu Tools. DEFAULT PIN: 0000.

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can't wait to enjoy your new high-denition digital terrestrial

receiver. The following quick guide will make you familiar with the basic operation of this device. We do,

however, advice you to read the full manual to get the best performance from your receiver.

To turn your receiver ON or to Standby, press q on the remote control.

Choose the desired channel with pq. Alternatively, you can press the channel number with the 0~9

buttons on the remote control or press OK in viewing mode to display the channel list. The volume can

be adjusted with tu.

6.0 OPERATION

Your new receiver is equipped with several features to make watching TV a true pleasure. This paragraph

describes these features. Please do also read chapter 7.0 to get familiar with the menu of your receiver.

6.1 Changing channels

Following ways are possible for changing channels with your new receiver:

 Via direct access using the 0~9 buttons.

 Via the channel list through OK and the pq buttons.

 Via the pq buttons.

6.1.1 Direct access via 0~9 buttons

To gain direct access to a certain channel, simply enter its number with the 0~9 buttons on the remote

control. Channel numbers can be up to four digits long. Entering a number with less than four digits

is possible. Just wait a few seconds and your receiver will switch to the selected channel or press OK

immediately after selecting the channel number.

Other manuals for Strong SRT 8215

Questions and Answers:

Need help?

Do you have a question about the Strong SRT 8215 and is the answer not in the manual?

General