Strong SRT 8215 - 7.3.5 Timers Setting; 7.3.6 Parental Lock

Region: Select or check region to dene timezone.
GMT Usage: Set By Region for broadcaster dened time depending of country selection
you made in the First Installation Wizard. Normally, the clock/time will be
correct and also follow up the summertime changes automatically. In some
regions close to neighbouring countries it can happen that the wrong time
zone is followed. In this case select the option User Dened to set up time
manually in the next steps below.
GMT Oset: Allows you to adjust the time zone you live in. This option is only available
when GMT Usage is set to User Dene.The GMT Oset range is “-11:00 ~
+12:00”.
7.3.5 Timers Setting
This menu allows you to set up to 8 timed events for waking up the receiver.
Use pq to select Timer from the Settings menu and press OK to enter.
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you wish
to set or change with pq and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode: Choose between Once and Daily Timer or select O, then Timer will execute
the scheduled event.
Timer Service: Select Channel to wake-up the receiver and switch to the selected channel.
Select Record to start record from the selected event to an externally
connected USB device.
Wakeup Channel: Press OK to open the channel list and use pq to select the channel where
the timer will wake up with.
Wakeup Date: Use the 0~9 buttons to enter the date for the timed event.
On Time: Use the 0~9 buttons to enter the start time.
Duration: Use the 0~9 buttons to enter the timer duration.
When all settings are according to your wishes, use pq to move the highlight to Save and press OK to
conrm. To quit the timer without saving your settings press 9.
7.3.6 Parental Lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
create a new PIN code. Use pq to select Parental Lock from the System Setup menu and press OK to
proceed. You will be asked to enter your PIN code. (DEFAULT PIN: 0000)
Menu Lock: Locks the installation menu. You can set the Menu Lock to On or O.
Rating Lock: Choose between: O no lock, Age 7, Age 12 and up to 18 years. Channels with
a parental rating above the chosen age will be protected with a PIN code (if
available in your local broadcast.)
New Password: Enter your new PIN code (4 digits) you'd like to use. (Make a note of it.)
Conrm Password: Re-enter your new PIN code to conrm. If successfully is entered, massage will
shown on screen. Press OK to end and save the change.
14